CUSTOM ENGINEERING TG2460 DRIVER DOWNLOAD

The operations described are valid for all models. Do not carry out repairs on the machine yourself, except for the normal maintenance operations given in the user manual. In the following figures are shown the examples: Please enter a message. Command Emulator 2 Command List 2. The relationship between the image data and the dots to be printed is as follows: Use the scroll bar next to the bookmarks More information.

Uploader: Daigor
Date Added: 9 April 2017
File Size: 51.78 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 91177
Price: Free* [*Free Regsitration Required]

Custom Engineering TG series Manuals

If the host is not ready, the printer waits until it is. Macro definition starts when this command is received during normal operation. Infinity offers great engineeting, excellent customer support and a wide range of payment processing solutions. When underline mode is turned off by setting the value of n at 0 or 48, the following data is not underlined.

This command is available for built-in characters and user-defined characters. After printing a bit image, the printer returns to normal data processing mode.

When the LSB of n is 1, the panel keys are disabled. The macro definitions are not cleared. The default More information.

Save to an existing parts list Save to a new parts list. There may therefore be a time lag between receiving the command and transmitting the data, depending on the status of the reception buffer.

  IHOME IH-M126LR DRIVER

TICKET PRINTER. TG1260 series TG2460 series 60 mm

Lift the wicket relative to paper roll compartment, and check that there are no scraps of paper at the area indicated with a letter near the printing head. Notice This document More information. The signals on the pins of the USB connector are as follows: The spacing to the right of the character for double width mode is double that used for normal mode.

entineering

Receipt Printer User s Manual However, the setting of the last received command is effective. Xiamen Rongta Technology Co. Count-up mode is specified when: There are no priority commands; engineernig commands are carried out when the circular buffer is free to do so.

Use the type of electrical power supply indicated on the printer label. When the characters are enlarged, the spacing to the right of the character is m 2 or 4 times the normal value. No part of this publication may be reproduced, stored in a retrieval tf2460, or transmitted in any form or by any means, electronic.

Even if a paper feed exceeding 2 lines is set, the printer only feeds the paper by 2 lines. If this command is entered in Page mode, the printer all the same save the setting. At the highest level, the protocol consists of a set More information.

  3.SIGAMATEL 9721 AUDIO DRIVER

Do not spill liquids onto the machine. Back view 4 4 The back view is the same for all models available. Disabled D or enabled. After printing is over, this command sets the print starting position at the beginning of the line.

Custom Engineering TG2460 series Manuals

The check is carried out on line, i. To contact our Technical Support: This command is not affected by bold, double-strike and underline etc. Standard interfaces Serial RS During the setup routine the printer prints custkm the setup report and will remain in standby until another key is pressed or characters are received through the printer communication port. Brother is a registered trademark of Brother Industries.